ZyXEL VMG8324-B10A - VDSL Settings
- Username: admin
- Password: 1234
2. On the Connection Status (Network Map) page, If you are presented with the Quick Start window > tick Don't automatically show this Quick Start after login > click Close.
Hover over Network Setting> click Broadband.

3. On the Broadband page, on the Broadband tab (default) > for the VDSL entry> under Modify, click Edit (pencil Icon).

4. On the WAN Configuration edit window, ensure you scroll through and verify the following settings are shown/specified below:
- General
- Active [Ticked]
- Mode: Routing
- Encapsulation: PPPoE
- IPv6/IPv4 Mode: IPv6/IPv4 DualStack (you can also use IPv4 Only)
- PPP Information
- PPP User Name: [user]@dsl.vygr.net (NOTE: [user] is your unique user name and can be found on your Build Doc)
- PPP Password: (Your Account password that was assigned to you).
- PPP Trigger Type: [Auto Connect]
- PPPoE Service Name : [Nothing Specified]
- PPPoE Passthrough : [Unticked]
- IP Address
- Obtain an IP Address Automatically [Ticked]
- Routing Feature
- NAT Enable: [Ticked]
- Fullcone NAT Enable : [Unticked]
- IGMP Proxy Enable : [Ticked]
- Apply as Default Gateway : [Ticked]
- DNS server
- DNS: [Static]
- DNS Server 1: 114.23.1.1
- DNS Server 2: 114.23.2.2
- IPv6 Address
- IPv6 Address:
- [Automatic is selected]
- Get IPv6 Address From DHCPv6 Server(IA_NA) [Unticked]
- Prefix Delegation(IA_PD) [Ticked]
- IPv6 Routing Feature
- MLD Proxy Enable : [Unticked]
- Apply as Default Gateway [Unticked]
- IPv6 DNS Server
- VLAN
- Active : [Ticked]
- 802.1p : 0
- 802.1q : 10
- QoS
- Rate Limit : [Nothing Specified]
- WAN Outgoing Default Tag : [Disabled]
- MTU
Click Apply.

5. Click the Connection Status (button situated on the bottom left), ensure you see a Green connection between your ZyXEL Router and the Internet icon. 
NOTE: If bundled with your plan, you may also wish to setup your VOIP (SIP) Subscription.
|